In Stock

AQUA QUARTZ

Coverage:
2 gallons (367.9 ounces) covers approximately 50-60 sq. ft. (1 coat recommended), depending on application method and surface conditions.

Color Disclaimer:
Please note that the color swatches shown on this website are intended to serve as a close representation only. Actual colors may vary due to a variety of factors. Click here to read the full disclaimer.

How many unit(s) do I need for my project?

It will depend on the square footage of your application.

A. Dimensions of surface:

feet long by
feet wide.

B. Number of coats:

SKU: N/A Category:

Classic AquaQuartz is a one-part quartz sand system designed to effortlessly transform your space with breathtaking results. Pre-mixed for your convenience, this revolutionary formula delivers a flawless, high-end finish with superior durability in just one step. Whether it’s for retail stores, garages, driveways, walkways, porches, steps, pool decks, or walkways, AquaQuartz gives you pro-level strength and beauty, without the hassle. Say goodbye to complicated mixes and long wait times. With AquaQuartz, you simply apply, cure, and seal and your project is complete in hours instead of days! Can be used on horizontal and vertical applications in both interior and exterior areas. Caution: Surface may be slippery when wet. New concrete must cure for 28 days before the product can be applied.

SURFACE PREP:

We highly recommend that the surface be primed before applying AquaQuartz. Using Classic First Prime (CW500), apply one coat and allow to dry for 1 hour for indoor projects or 30 minutes for outdoor projects. Classic First Prime is available in a clear, gray, or tan base. Only prime if you are applying AquaQuartz on the same day.

MIXING:

Mix for 4-5 minutes using a drill and mixing paddle (Model: Collomix FM80S for 2 gallons) or (Model: LX120S for 4 gallons). Always mix before each use to prevent solids from settling at the bottom.

APPLICATION:

Application surface temperature should be between 50ºF and 85ºF. The surface must be primed before applying AquaQuartz. Using Classic First Prime, apply one coat and allow to dry for 1 hour for indoor projects or 30 minutes for outdoor projects. (See Classic 1st Prime’s label and/or TDS for more detailed application instructions.) Use an 18” x 3/16” notched trowel to apply the product, then lightly smooth over the notch lines with the flat side of the trowel. Do not overwork AquaQuartz. Evenly spread the AquaQuartz across the prepared surface. Standard application is 1 coat at 1/16”. If a second coat is required, wait 3 hours after applying the first coat. Coverage per unit is 50-55 sq. ft. (depending on the surface and application at 1/16”). Allow AquaQuartz to dry for 3 to 4 hours before applying a Classic Sealer.
Allow Sealer to cure for 24 hours for light traffic, 48 hours for heavy traffic, and 5-7 days for vehicle traffic. (Instructions applicable to 75ºF surface temperature)

We recommend the following Classic Sealers:
• W455 Polyurethane 1k for light traffic. (2 Applications)
• Classic Armor 2k Aliphatic Polyurethane for heavy traffic.

For added slip-resistance, spread AquaQuartz when applying the sealer and while the surface is still wet.

Additional information

color

Sierra Sand, Midnight, Rose Petal, Oyster, Pacific Island, Storm, Sandy Shore, Caribbean Blend, Gemstone, Seashell, Sand Dollar, Onyx Gray

size

2 Gallons

Reviews

There are no reviews yet.

Be the first to review “AQUA QUARTZ”

Your email address will not be published. Required fields are marked *