Classic Nano-Infused Concrete Stain is a specially formulated non-reactive semi-transparent stain that will penetrate and color most porous surfaces. It can be mixed with water, acetone, or denatured alcohol. It is a ZERO VOC product with no odor and cutting-edge technology to bring you the smallest particle size available in a concrete stain to allow the greatest penetration. It is ideal for interior or exterior use as it is UV-protected and will not fade in the sun. It is packaged as a liquid concentrate. Mottled looks similar to acid or dye stain applications can be accomplished with application techniques. Nano-Infuse can be sealed with Classic water base sealers or solvent sealers within two hours of drying. Application is easiest with a pump sprayer with a conical tip. Tip size of .05 to .15 gpm at 30-40 psi is recommended to reach coverage rates of 400-600 sqft. per gallon. New concrete must cure for 28 days before stain is applied. Available in 1 quart concentrate. See Tech Data Sheet for mixing instructions.
ADVANTAGES
- Low cost, easy to use, and low maintenance
- Multiple colors can be used for
unique and beautiful results - Semi-transparent finish
- Can be used on interior and exterior surfaces
- UV stable and Zero VOC
- Protects and preserves against wear and
exposure when sealed - In most cases, it can be sealed with a Classic
Coatings Sealer on the same day
LIMITATIONS
- If a uniform color is desired, Classic CDC line is
recommended - Not for use on self-leveling cement or light
weight concrete - Must be installed over a clean dry surface. Surface
should feel like it is under 100 grit sandpaper - Moisture & efflorescence must be removed
before applying stains or sealers - Clean surfaces with Classic Super Eco-Etch
Cleaner then power wash and rinse well - Never apply adhesive tape over stained or
sealed surfaces as it may cause damage. Once
sealed, allow 5-7 days before parking
TYPICAL USAGE
Nano Infused Concentrate Classic Nano Infused Concentrate can be used anywhere architectural concrete is desired. Both interior and exterior, on almost any cementitious surface, whether it be gray or color harden concrete, stamped or textured concrete, micro-toppings or overlays. It can be used as an entire surface colorant or just as an accent border or detail. It may be used on both new and existing substrates. Typically used as flooring in restaurants and food service areas, bars, hotels, casinos, retail stores, malls, art studios, movie theaters, museums, pool decks, automobile showrooms, residential flooring and more. Classic Stains may also be used as a means to color poured in place concrete; both smooth or with a form linear, tilt up wall, stoneface plaster, GFRC, and faux rock.
Note: In some cases if a reaction cannot be achieved the substrate may need to be resurfaced with a cementitious topping such as Classic Micro Topping (indoor applications only) and Classic Stampable Overlay (outdoor applications only). The benefit to resurfacing is to provide a virgin canvas without the effect of patches, repairs, existing stains, mastics, glues, oils, etc.
Reviews
There are no reviews yet.